Enerpac L2586 Instruction Sheet

L2586 Rev B
Index:
English .......................................................... 1-4
Français ........................................................ 5-8
Deutsch ..................................................... 9-12
Italiano ...................................................... 13-16
Español .................................................... 17-20
Nederlands .............................................. 21-24
Portuguese ............................................. 25-28
................................................... 29-32
中文
...................................................
Repair Parts Sheets for this product are
available from the Enerpac web site at www.
enerpac.com, or from your nearest Authorized
Enerpac Service Center or Enerpac Sales
office.
1.0 IMPORTANT RECEIVING
INSTRUCTIONS
Visually inspect all components for shipping
damage. Shipping damage is not covered by
warranty. If shipping damage is found, notify
carrier at once. The carrier is responsible for
all repair and replacement costs resulting from
damage in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
Read all instructions, warnings
and cautions carefully. Follow
all safety precautions to avoid
personal injury or property damage during
system operation.
responsible for damage or injury resulting from
unsafe product use, lack of maintenance or
incorrect product and/or system operation.
Contact Enerpac when in doubt as to the
safety precautions and operations. If you have
never been trained on high-pressure hydraulic
safety, consult your distribution or service
center for a free Enerpac Hydraulic safety
course.
Failure to comply with the following cautions
and warnings could cause equipment damage
and personal injury.
A CAUTION is used to indicate correct
operating or maintenance procedures and
practices to prevent damage to, or destruction
of equipment or other property.
05/2019
Enerpac cannot
33-35
A WARNING indicates a potential danger that
requires correct procedures or practices to
avoid personal injury.
A DANGER is only used when your action or
lack of action may cause serious injury or even
death.
5,000 full pressurization cycles. THIS LIMIT
SHOULD NOT BE EXCEEDED. Use of these
danger.eps
cylinders beyond their rated life can lead to
sudden failure without warning and could
cause property damage, injury, or death.
The base holes in these aluminum cylinders
are designed for securing the steel base plate.
danger.eps
They will not withstand the capacity of the
cylinder. Do not use the base holes in these
be
aluminum cylinders to attach any device to the
cylinder.
sgls.eps
should never be used as a load holding
undr.eps
device. After the load has been raised or
lowered,
mechanically.
®
capable of supporting the load. Never use a
blkd.eps
Instruction Sheet
Aluminum Cylinders
WARNING: Aluminum cylinders
sold by Enerpac
designed to safely withstand up to
WARNING: The steel base plate
protects the cylinder base from
damage and should not be removed.
WARNING: Wear proper personal
protective gear when operating
hydraulic equipment.
WARNING: Stay clear of loads
supported by hydraulics. A cylinder,
when used as a load lifting device,
it must always
WARNING: USE
PIECES TO HOLD LOADS. Carefully
select steel or wood blocks that are
have been
be blocked
ONLY RIGID