Table of Contents
Advertisement
Step5. When Z308 can not join a network in 3 minutes, it will go into off mode. To ask for
joining Network again, press and hole button for 3 seconds.
After joining a network, Z308 would try to enroll in the ZigBee security system. Please make
sure Z308 and CIE (Control and Indicating Equipment) device have enough power.
5-4. Enroll in the ZigBee Security System
Z308 is a Zone device in the ZigBee security system. Right after Z308 join the ZigBee network, it
will automatically find out a CIE (Control and Indicating Equipment) device and send a registration
request to the CIE device to enroll in the security system. The enrollment has these 3 situations:
A. There is no CIE device or no compatible CIE device in the network
→ the indicator flashes red twice.
B. There is a compatible CIE device in the network, but it is failed to enroll
→ the indicator flashes red 4 times. Users can reboot Z308 to initiate the registration.
C. The enrollment is completed
→ the indicator flashes red 6 times.
Note:
Users had better NOT enroll multiple Zone devices at the same time to prevent registration failure.
5-5. Sleeping Mode
Z308 is designed to go into sleeping mode for power-saving in some situations:
A. While the device is in the network → the sleeping period is 5 minutes; it will wake up every
5 minutes to keep online.
B. Once Z308 was joined to a network and by any chance the network is no longer existed or the
device is out of the network → Z308 will wake up every 5 minutes to find the network it
joined before.
It never keeps in sleeping mode and continues to find out a network every 5 minutes. This condition
would consume up to 30 times power spending compared to normal-operating status. To prevent this
unwanted power consumption, we recommend that users turn off the device.
6
Advertisement
Table of Contents
