5.Setting up Z308
5-1. Power On
Without external power supply, the product uses internal 3V button battery for power supply.
Step1. Open the battery back cover
Step2. Take a CR2450 button battery, put the negative pole upward into the battery base
Step3. Cover the back cover and lock the screws
Step4. Long press the alarm key for 3 seconds, and the LED lights flash once respectively,
indicating that the power on is successful
5-2. Turn On/ Turn Off Z308
To manually turn on or turn off Z308, please use the following instructions:
Turn it on: Press and hold the Panic Button for 3 seconds. The indicators will flash once, and the
device is ready to be used.
Turn it off: Press and hold the Panic Button for 6 seconds. The indicator will flash red 10 times
within 5 seconds. Within the 5-second period of time, press the Panic Button again to
turn it off.
5-3. Join the ZigBee Network
After Z308 is turned on, it will search for an existing ZigBee network and send a request to join the
network automatically. While Z308 is under the coverage from a coordinator or a router whose
permit-join feature is enabled, Z308 will be permitted to join the network.
Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please
refer to the user manual of the coordinator or the router to enable the permit-join feature).
Step2. Turn on Z308. It will start to search and join the network.
Step3. Press and hold button for three seconds to search a network to join.
Step4. The indicator will flash green 5 times after it is joined successfully. Otherwise, the
indicator will not flash.
5