Advertisement
13. Rotate the zooming ring to the WIDE side until the background
color of the value (hexadecimal number) at the lower left of the
window changes to light blue.
Note 2: If you rotate the zooming ring in small increments to the
TELE/WIDE side for fi ne adjustment, an error may occur.
Rotate to only one direction (WIDE side) and adjust the
position.
If it deviates from the specifi ed position, return to TELE
side greatly and try again.
14. When the ENTER key is pressed, automatic adjustment of POS9
is started.
15. After the automatic adjustment of POS9 is completed, "ZOOM
- POS10" is displayed.
16. Repeat the operations from step 13 to step 15 to "POS15".
17. After the automatic adjustment of POS15 is completed, "FB
ADJUSTMENT OK" is displayed.
18. When the ENTER key is pressed, recording the adjustment data
and releasing from adjustment mode are performed automatically,
and "FINISHED" is displayed when the process is completed,
then click the [OK] button.
(6) F Number (S)
• Perform focus actuator inspection.
• Perform actuator damage inspection.
• Adjust the F number.
Subject
Operation on Lens side
Type of the camera
Shooting Mode of the camera P mode (Program Auto)
Adjusting Method
1. Click the [F Number (S)] button in the Adjustment and Inspec-
tion.
2. "Set to [WIDE] Pos." is displayed, set the zooming ring to the
WIDE end (focal length: 24 mm).
Zooming ring
3. When the ENTER key is pressed, automatically starts the each
adjustments and inspections.
4. After the adjustments and inspections are completed, "F Number
/ Act CHECK OK" is displayed.
5. When the ENTER key is pressed, recording the adjustment data
and releasing from adjustment mode are performed automatically,
and "FINISHED" is displayed when the process is completed,
then click the [OK] button.
5-30
SEL24105G
Not required
• Zooming ring
ILCE-5000
Advertisement
