Installation - DENTSPLY ProMix 400 Repair Manual

5.0

INSTALLATION

NOTE: Upon receiving the ProMix™ system check the packaging and parts for
any damage that may have occurred in transit. If damage is apparent,
please contact your dealer immediately.
Unit Power-up (Initialization):
Plug the detachable power cord into the back of the unit and then to the mains supply.
NOTE: Always use the unit in conjunction with a properly grounded outlet.
Activate the Power Switch on the back of the unit.
Upon the application of AC power, the unit shall always be initialized as follows:
- the Display Board shall read "00",
- the motor shall be OFF,
- the "LOW" motor speed shall be selected and the "LOW" LED
indicator shall be ON.
NOTE: AC power interrupts and degradation causing improper operating
voltages to the microprocessor shall always result in a microprocessor
master reset and re-Initialization of the unit.
Definition of Terms:
Initialization:
Stand-By:
Run:
is the function performed by the software of the unit after
power up or master reset.
is the condition when the unit is not performing the
amalgamation cycle but has completed the
"initialization" period.
is the condition when the unit is performing the
amalgamation cycle.
5