Programming; To Add A Remote Control; Door Control (Myq Control Panel) - Chamberlain 8500 Manual

Programming

Your hand-held remote control (model 893MAX) has already programmed to the door control (myQ Control Panel) at the factory. Below
are instructions for programming additional remote controls and keyless entries to the door control.
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door opener will NOT
program accessories.
To Add a Remote Control or Keyless Entry using the Door Control (myQ Control
Panel)
REMOTE CONTROL
1. Press the myQ Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
KEYLESS ENTRY
1. Press the myQ Control Panel LEARN button twice, the
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keyless entry keypad. Then press
the ENTER button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
Command
LED (yellow)
Learn LED
(Red)
26
? ? ? ?
PIN