Table of Contents
Advertisement
The pilot panel can control the locations for the six receive audio locations
for all users. Press and hold the OXY button for >3 seconds on the pilot's
panel until the HRTF button and all COM nomenclature start blinking
green.
Rotate the desired COM receive volume knob so the pointer indicates the
approximate location of the desired location. A voice announcement will
accompany the knob rotation with the clock positions. Received audio will
then be presented from that location.
Press the OXY (or HRTF) button again to exit the
mode. The audio Controller will remember last state
through power cycles.
Navaid Audio Selection
Navigation receivers are selected in the same manner
as the communication receiver, pull on/push off the knob associated with
the desired navigational aid, and rotate to adjust the receiver volume.
Speaker operation
To activate the cockpit speaker, pull the SPR knob out and adjust the vol-
ume as desired. This will place all received audio over the cockpit speaker.
Both pilot & copilot have their own separate cockpit speaker selection.
Satellite/Telephone control
The volume control selector connects the audio controller to
either a Bluetooth®-enabled cell phone or a wired cellular/
satellite phone.
Pull out the volume control to select (answer or make phone
call) and adjust the receive audio volume. This knob must be out
to use the telephone function.
To hear the ringer of the Bluetooth phone, the volume control should be
around the 12 o'clock position. Selecting the SAT switch in the OUT posi-
tion is not required.
Intercom Operation
IntelliVox® Intercom VOX-Squelch
No adjustment of the IntelliVox® squelch control is nec-
essary. Through three individual signal processors, the
ambient noise appearing in all six microphones is con-
stantly being sampled. Non-voice signals are blocked.
When someone speaks, only their microphone circuit
opens, placing their voice on the intercom.
PAC45L Pilot Guide
202-045-3000
Page 5
Advertisement
Table of Contents
Need help?
Do you have a question about the PAC45L and is the answer not in the manual?
Questions and answers