Table of Contents
Advertisement
[ENG] Resetting Parameters to Default Values
Resetting parameters of a device to default values is necessary in the next cases:
•
Login and/or password for accessing a device web interface is lost;
•
There is no information about a current IP address of a device;
•
In certain cases after updating firmware of a device
This procedure sets all configured parameters of a device to default values (IP and MAC addresses, access filters,
user name (login), password).
To reset the parameters to default values, perform the next actions sequentially:
1.
Press and hold a reset button «Reset» for more than 5 seconds (use a pen/a stylus/a pencil, etc.);
2.
Release a reset button «Reset». CPU LEDs near Ethernet ports will blink. All parameters of a device are set to
default values.
Short press on a button for resetting parameters «Reset» reloads a device.
On default, the next parameters of a device are set:
User name: visor
Password: ping
IP address: 192.168.0.100
Subnetwork mask: 255.255.255.0
Gateway: not set
SNMPcommunity: SWITCH
MAC-address: 00 a2 xx xx xx xx
Here xx xx xx xx corresponds to a serial number of a device. Thus, all devices after being manufactured have
unique MAC-addresses.
After resetting parameters to default values, there is a need to perform an initial configuring of a device. For more
details, see the document "Firmware Description"
[ENG] NetPing 4/PWR-220 v4/SMS, User guide -[ENG] Resetting Parameters to Default Values
(Where to Get a Document Describing Firmware).
[ENG] Resetting Parameters to Default Values
–
Advertisement
Table of Contents
