Table of Contents
Advertisement
[ENG] NetPing 2 IP PDU ETH 53R14 & NetPing 2 IP PDU GSM3G 203R15, User guide -[ENG][2PWR] Resetting Parameters to Default
[ENG][2PWR] Resetting Parameters to Default Values
Resetting parameters of the device to default values is necessary in the next cases:
•
a login and/or a password to the web interface of the device is lost;
•
no information about a current IP address of the device;
•
in some cases, after the firmware update procedure
This procedure sets all configured parameters of the device (an IP-address, access filters, a user name, a password,
and other settings) into the default values.
To reset parameters in default values, perform the next actions one by one:
•
disable the external module for batteries 85M2;
•
power off the device;
•
click the «Reset» button for resetting parameters;
•
switch the device on, while keeping the «Reset» button pressed during 15-20 seconds;
•
release the button, all parameters of the device are reset to default values.
Quick clicking the button for resetting parameters «Reset» reboots the device.
The device has got the next default parameters:
The User name: visor
The Password: ping
The IP address: 192.168.0.100
The Subnet mask: 255.255.255.0
The Gateway: not set
SNMP community: SWITCH
MAC-address: 00 a2 xx xx xx xx
Here, xx xx xx xx corresponds to a serial number of a device. Thus, all devices have unique MAC addresses after
manufacture.
[ENG][2PWR] Resetting Parameters to Default Values
Values
–
Advertisement
Table of Contents
