Handling And Use; Charging Mobile Devices With The Power Bank - Silvercrest SPBD 5000 A1 Operating Instructions Manual

Handling and use

Charging mobile devices with the power
bank
♦ Connect the micro-USB plug on the charging cable
to the micro-USB port on the mobile device and the USB
plug to the USB socket (OUT)
charging process starts automatically.
♦ If charging does not start automatically, press the ON/
OFF button
NOTE
► Alternatively, you can also use the original charging
cable (USB cable) provided by the respective device
manufacturer.
► Some devices cannot be charged due to the high start-
up charging current required (higher than 2.1 amps).
♦ During the charging process, the current Power Bank
charge level is shown via the charge level LEDs
table in section entitled "Checking the charge level").
♦ To stop charging, disconnect the charging cable
the mobile device and the power bank. The charge level
LEDs switch off .
SPBD 5000 A1
briefl y to start the charging process.
on the power bank. The
GB│MT
(see
from
57 ■
│