Life Fitness CLUB Series Assembly Instructions Manual page 10

FIGURE 9
32
33
HEAVY WEIGHT OPTION
STEP 9:
• Insert the two GUIDE RODS (34) (found in SHROUD KIT box) into the base of the TOWER (1) as shown in FIGURE 9. Lubricate
the GUIDE RODS (34) with a silicone or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (24) down over the GUIDE RODS (34). See FIGURE 9.
• Using EXTREME CARE place twenty 10 LB. WEIGHT PLATES (32) over the GUIDE RODS (34) as shown in FIGURE 9.
(NOTE: If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (33) over the GUIDE RODS (34)
first, then slide ten 10 LB. WEIGHT PLATES (32) over the GUIDE RODS.)
• Carefully Slide the HEAD PLATE (9) down over the GUIDE RODS (34) onto the weight stack as shown in FIGURE 9.
• Slide one WEIGHT STACK SELECTOR PIN (23) over the shaft on the HEAD PLATE (9) as shown in FIGURE 9.
• Slide two 1" SHAFT COLLARS (28) over each GUIDE ROD (34) as shown in FIGURE 9.
• Slide two GUIDE ROD BUSHINGS (29) over each GUIDE ROD (34).
• Place the GUIDE ROD SUPPORT (8) over the GUIDE RODS (34) as shown in FIGURE 9.
1/2
0
1/2 1/2
1 2
8
29
28
1
23
9
34
32
1A
24
1/2
3 4
10
1/2 1/2
5
6