Table of Contents
Advertisement
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the wash
cycle.
Cause and Troubleshooting
Resume the program by Centrifuge or Drain to
▶
choose and press Start/Refill
know.
→ "Resume program at rinse hold", page 33
Water drain hose is connected too high.
Install the water drain hose at a maximum height of 1
▶
meter.
Pump cover not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Unauthorized extension mounted on the water drain
hose.
Remove any unauthorized extensions from the
▶
water drain hose. Connect device
Start/Refill
Press Start/Refill
▶
Strainer in the water supply is clogged.
▶ Clean the strainer in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
Troubleshooting NL
was not pressed.
.
too busy-
47
Advertisement
Table of Contents
