Table of Contents
Advertisement
NL Troubleshooting
Malfunction
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:35 / -10"
44
Cause and Troubleshooting
Remove any unauthorized extensions from the
▶
water drain hose. Connect device
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
Drain pump is clogged.
→
"Cleaning the drain pump", page 39
▶
Drain pump is clogged.
→ "Cleaning the drum", page 38
▶
if the error is displayed again,
→
"Cleaning the drain pump", page 39
▶
Inlet opening of the rubber sleeve is clogged.
→ "Clean the inlet opening in the rubber sleeve",
▶
Page 42
Water pressure is low.
No solution possible.
Strainer in the water supply is clogged.
▶ Clean the strainer in the water supply.
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water supply hose is not
▶
kinked or pinched.
Water in the bottom tray.
Close the tap.
▶
Please contact customer service.
▶
→
"Customer Service", page 53
Device is leaking.
Close the tap.
▶
Please contact customer service.
▶
→
"Customer Service", page 53
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
Reduce the amount of detergent for the next wash
▶
with an equal load.
Advertisement
Table of Contents
