Table of Contents
Advertisement
3 – Preparation
Preparing the unit
Changing accessory shoe attachment
adapters
Change the accessory shoe attachment adapter to use an
analog connection with this unit or switch to a camera by a
different manufacturer.
For details about accessory shoe attachment adapters, see "j
Accessory shoe mount adapter" on page 7.
Changing the accessory shoe attachment
adapter
1.
Use a Phillips head screwdriver to remove the 2 screws that
affix the accessory shoe attachment adapter (j).
2.
Remove the accessory shoe attachment adapter from the
unit.
3.
Being careful to use the correct orientation, align the
replacement accessory shoe adapter with the unit.
8
TASCAM CA-XLR2d
4.
Use the 2 screws that were removed to affix the accessory
shoe adapter.
ATTENTION
Attach a connector cover to the removed accessory
shoe adapter. Failure to do so could result in this unit
malfunctioning due to the ingress of foreign matter or
connector damage, for example.
Preparing the power supply
This unit can be powered in two ways: from a camera or using
AA batteries.
Alkaline, nickel-metal hydride or lithium AA batteries can be
used.
Use AA batteries when any of the following considerations apply
to power supply from a camera.
o Power supply from a camera cannot be received
o Using the camera battery is undesirable
o Power supply is limited due to conditions that include the
camera battery or operating status
Using power supplied from a camera
Power can be supplied to the unit when a camera that can
supply power is connected.
For information about cameras that support power supply, refer
to the list of cameras that have been confirmed for operation on
the TASCAM website (https://tascam.jp/int/product/ca-xlr2d/
docs) or contact TASCAM Customer Support.
Advertisement
Table of Contents
