Recording; Turning The Power On; Ca-Xlr2D-C/Ca-Xlr2D-F; Ca-Xlr2D-An - Tascam CA-XLR2d Reference Manual

After completing preparation of connected devices turn on the
power supply for this unit.
In order to have this unit operate under the control of the
camera, operations and procedures according to the power
supply and image capture mode of the camera are necessary.
(When using a CA-AK1-AN, it will operate in standalone mode
requiring AA batteries.)

Turning the power on

CA-XLR2d-C/CA-XLR2d-F

When power supplied from camera
1.
Set the BATTERY POWERED switch (g) to "OFF".
2.
Turn the camera power on and set its operation mode to
"video recording".
This will start power supply from the camera, and the
POWER SUPPLY indicator (1) will light.
The input meter shown on the camera display will move
according to the input signal, allowing the transmission of
audio to be confirmed.
NOTE
Depending on the specifications of the connected camera,
an accessory connection indicator might appear on the
camera display.
When using AA batteries
1.
Set the BATTERY POWERED switch (g) to "OFF".
2.
Turn the camera power on and set its operation mode to
"video recording".
This will start power supply from the camera, and the
POWER SUPPLY indicator (1) will light.
NOTE
Depending on the specifications of the connected camera,
an accessory connection indicator might appear on the
camera display.
3.
Set the BATTERY POWERED switch (g) to "ON".
This will start power supply from the AA batteries, and the
POWER SUPPLY indicator (1) will light.
The input meter shown on the camera display will move
according to the input signal, allowing the transmission of
audio to be confirmed.
ATTENTION
i Since the CA-XLR2d-C and CA-XLR2d-F require control from
a camera, they cannot be operated using just AA batteries
when there is no power from a camera.
i Since the input sound will be muted when the BATTERY
POWERED switch (g) is switched, stop recording with the
camera temporarily beforehand.
4 – Recording

CA-XLR2d-AN

1.
Set the BATTERY POWERED switch (g) to "OFF".
2.
Turn the camera power on and set its operation mode to
"video recording".
3.
Set the BATTERY POWERED switch (g) to "ON".
This will start power supply from the AA batteries, and the
POWER SUPPLY indicator (1) will light.
The input meter shown on the camera display will move
according to the input signal, allowing the transmission of
audio to be confirmed.
ATTENTION
i When using a CA-XLR2d-AN, if the BATTERY POWERED switch
(g) is set to "ON", the batteries will be used. Set it to "OFF"
when done using.
i Since the input sound will be muted when the BATTERY
POWERED switch (g) is switched, stop recording with the
camera temporarily beforehand.
15
TASCAM CA-XLR2d