Table of Contents
Advertisement
IMPORTANT!
PARALLEL FUNCTION
PARALLEL FUNCTION
The total output power of the generators can be increased by connecting two inverter generators together using the
Parallel Unit from Könner & Söhnen. Parallel connection of two generators ensures total rated output power of these
generators. When two generators are connected in parallel, you will be able to get 90% of the total rated power of the
connected models. Connect the cables for parallel connection to the generators for increased power. Then start both
generators. Never connect or disconnect cables from a running generator. Disconnect cables only after disconnecting
consumers and turning off the generator.
ATTENTION - DANGER!
STOPPING THE ENGINE
STOPPING THE ENGINE
To stop the engine, proceed as follows:
1. Disconnect all devices connected to the generator, then disable the ECON mode.
2. Allow the generator to run idle for approx. 1-2 minutes.
3. Set the engine switch to the "OFF" position.
4. Turn the fuel valve to the "OFF" position.
Works, specified in "Technical maintenance" section, are to be regularily performed. If the the generator user has
no possibility to perform regular maintenance independently, it is necessary to address the official service center to
registrate an order for such works performance.
You can find a list of service center addresses in your warranty card.
IMPORTANT!
Level check
Motor oil
Replacement
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Fuel filter
Check (clean out)
The ECON switch must be set back to "OFF" when using electrical
devices requiring a high starting current, such as a compressor or
submersible pump.
DISCONNECT ALL THE DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator with the devices turned on. This may
disable the generator or devices connected to it!
TECHNICAL MAINTENANCE WORKS
MANUAL COMPLIANCE
Technical maintanance, operation and TM K&S Basic generator
storage are to be performed according to this manual recommen-
dations. Manufacturer bears no responsibility for damages and
losses, caused by incompliance to safety requirements and tech-
nical maintanance rules.
TECHNICAL MAINTENANCE WORKS
www.ks-power.de/en
8
| 7
Advertisement
Table of Contents
