To Set The Alarm; Compass; About The Compass; Compass And Calibration - Oregon Scientific RA126 User Manual

TO SET THE ALARM

1. Press MODE to navigate to Clock mode.
2. Press SET to navigate to Alarm.
3. Press and hold SET to enter settings.
4. Press ST / SP / + to scroll upwards and COMPASS /
- to scroll downwards through the setting options. The
setting sequence is as follows: hour; minute.
5. Press SET to confirm.
To activate or deactivate the alarm:
• Press MODE to navigate to Clock mode.
• Press SET to navigate to Alarm and press ST / SP / + to
turn the alarm on or off.
has been activated.
• Press SET to confirm.
NOTE
When the alarm clock is activated, it will sound at
the set time every day. Press any button to stop the alarm
will indicate that the alarm
for that day. The alarm clock is still active and will set off
again the following day.
To silence the keys:
• Press MODE to navigate to Clock mode.
• Press SET to navigate to Beep ON / OFF.
• Press ST / SP / + to silence or to turn on key sounds.

COMPASS

ABOUT THE COMPASS

The compass shows the bearing of your position in degrees
due North. The outer circumference of the display consists
of 60 segments that graphically show your bearing. Three
lit segments represent South whereas one lit segment
represents North, as shown below.
５

COMPASS AND CALIBRATION

Before the compass is first used, we recommend that you
calibrate the compass sensor.
To calibrate the compass sensor:
• Press MODE to navigate to the Set up mode.
7
1. South
1
2. Bearing
２
3. Stopwatch
３
4. Cardinal point
４
5. North