Table of Contents
Advertisement
TO ENABLE OR DISABLE AUTO-
RECEPTION
If you wish to disable the auto-reception feature while the unit is
within range, press and hold the SPLIT (DOWN) button for 2
seconds. The antenna indicator will disappear and the unit will
NOT respond to radio signals.
To enable the feature again, press and hold the START/STOP (UP)
button for 2 seconds. The antenna indicator will start blinking to
initiate reception automatically.
SETTING THE CALENDAR CLOCK
MANUALLY
When the unit is not within range of the radio signal, you can set the
time and calendar manually.
1. Press and hold the MODE button for 2 seconds.
2. Enter the year using the START/STOP (UP) or SPLIT (DOWN)
buttons. Hold down either button to rapidly increase or decrease
the value.
3. Press the MODE button to confirm the entry.
4. Enter the months using the START/STOP (UP) or SPLIT
(DOWN) buttons. Press the MODE button to confirm the entry.
5. Follow the same pattern to set the days, hours, minutes, seconds
nd
and 2
time-zone hour-offset (+/- 12 hours).
6. For second-setting, if its value is between 0 to 29, press either
START/STOP (UP) or SPLIT (DOWN) button will return to
the present minute. If its value is between 30 to 59, it will proceed
to the next minute. (e.g., when the time is 12:46:28, it will return
to 12:46:00; when the time is 12:46: 48, it will go to 12:47:00).
7. For the 2nd time-zone setting, please note that the 2nd time-
zone hour-offset function comes with automatic Daylight Saving
Time (DST) compensation. When the hour-offset is set from+1
to -12 hours, the 2nd zone-time will synchronize with DCF-DST
and be adjusted automatically. However, when the hour-offset
is set from+2 to +12 hours, no DST compensation will be made.
8. Press the MODE button to save the changes and exit. The unit
will also save all changes and return to normal display
automatically after the unit has been left idle for 2 minutes.
ABOUT THE ALARM
To set the alarm:
1. In the Alarm time display mode, press and hold the MODE
button for 2 seconds and the hours will flash.
2. Use the START/STOP (UP) or SPLIT (DOWN) buttons to enter
the hours.
3. Press the MODE button to confirm.
4. Use the START/STOP (UP) or SPLIT (DOWN) buttons to enter
the minutes.
5. Press the MODE button to confirm.
4
Advertisement
Table of Contents
