Table of Contents
Advertisement
Make sure the power supply corresponds to the voltage and frequency indicated on the dust collector
plate.
Warning!
Do not fit the plug in the power socket with wet hands.
In the event of an extension cord being used, make sure this is in perfect condition, in compliance with CE
standards and with cable cross section suitable for the power input of the dust collector.
➢
Pull the red handle on the left side of the dust collector and unlock the sliding system.
➢
The dust collector will raise automatically, however it is possible to use the superior handle to guide
the movement with a balanced force.
➢
Pull the dust collector until the lock has reached its position.
➢
If the operator notes that the movement becomes difficult, remove the side cover, loosen the screws
and if necessary put some grease on the sliding system.
- 14 -
Operation Section
Advertisement
Table of Contents
