CPI Satcom & Antenna Technologies
SECTION II
CAUTION: During the assembly procedure, the sequence of instructions must be
followed. Do Not Tighten Any Hardware Until Instructed. Refer to
the antenna assembly parts list and the following steps.
2.0
ANTENNA ASSEMBLY
Existing Hardware
Positioner
Rotation
Bolt
90
ANTENNA SYSTEM ASSEMBLY
Positioner Assembly
Canister
Plate
STEP 1:
A). Remove azimuth rod from positioner
assembly.
B). Set azimuth rod and related hardware aside.
Azimuth Rod
STEP 2:
A). Loosen rotation bolt on top of positioner.
B). Rotate the positioner so that the canister
plate is oriented as shown.
C). Lightly tighten rotation bolt.
9
4096-394
1.8M SERIES 1194