Table of Contents
Advertisement
11970 Series Harmonic Mixers
Figure 1-1
Options
Option 009, shown in
Figure 1-2 on page
cables (Part Number 5061-5458), one hex-head balldriver (Part Number 8710-1539) for tightening the
waveguide connector screws, and one 5/16-inch open-end wrench (Part Number 8710-0510) for use on
the SMA connectors.
Spectrum Analyzer Retrofit Requirements
• N9030A Signal Analyzer
— A Diplexer is required since the N9030A has a single SMA external mixer port, and the 11970
series mixers have separate LO and IF ports. The recommended diplexer can be purchased from
Agilent as p/n N9029AE13 or from OML Inc. as p/n DPL.313B.
— Requires Option EXM
To retrofit Option EXM:
Retrofit kits (N9030AK-EXM) are only available for N9030A with Option 550, 544, or 543.
o
At this time, you cannot retrofit instruments with Option 503, 508, 513, or 526.
o
— Software revision must be A.08.01 or later
— The N9030A does not support the 11970K (LO range limitation).
• PSA Series E4440A, E4446A, and E4448A spectrum analyzers require Option AYZ (LO OUT and
IF IN connectors). The E4443A and E4445A do not support external mixing.
• 856x Series portable spectrum analyzers with options 002 (tracking generator) and 327 (no IF IN on
front panel) do not have external mixing capability.
12, is a Mixer Connection Kit. It includes three low-loss SMA
General Information
Introduction
11
Advertisement
Table of Contents
