HOLMS SL Operator Instructions Manual
Hydraulic sweeper 2,0/2,2/2,5m
Hide thumbs
Also See for SL:
- Operating instructions manual (29 pages) ,
- Operator instructions manual (10 pages)
Subscribe to Our Youtube Channel
Related Manuals for HOLMS SL
Summary of Contents for HOLMS SL
- Page 1 OPERATOR INSTRUCTION Hydraulic sweeper 2,0/2,2/2,5m From serial No: 5017. Box 924 S-591 29 Motala Sweden • Tel +46 141-22 41 00 • Fax +46 141-22 41 90 © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06...
-
Page 3: Table Of Contents
- Check that the carrier is appropriate to the attachment (hydraulic flow, stability etc.) When ordering spare parts or by other contacts with Holms or your local dealer, always inform about the attachment type and series No. This number you will find on the ma- chine plate. - Page 4 © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06...
-
Page 5: Generally About The Sweeper
Generally about the sweeper The SL sweeper is made for small wheel loaders and trac- tors mounted in the front or rear of the machine. SL ope- rates with two direct acting hydraulic motors designed for an oil flow of 40-130 l/min. -
Page 6: Operator Instruction
(picture 7) to set the ground pres- sure. Attention! Do not use the carrier lifting or tilting function for ground pressure setting. Warning! Always stop the broom completely before making any adjustments. 7. Adjusting grip © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06... -
Page 7: Sweeping
3. Put down the sweeper on the ground. 4. Loosen the quick couplings for the 3:rd and 4:th hydrau- 11. Supports in parking position lic functions alternatively hydraulic motor circuit and the ca- ble. © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06... -
Page 8: Maintenance
Also check eventual oil leakage. Lubrication 12. Bar tube bearing A couple of times a year, the bar tube bearing shall be greased. Clean the nipple and fill in until the grease pierces. © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06... -
Page 9: Change Of Brushes
5. Angle the sweeper roll from the bar tube and pull the roll out from the carrier housing on the other gable side. 14. Removing the bolts 15. Removing the gable side © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06... -
Page 10: Change Of Brushes
13. Fasten the other end ring with screws. 18. Mounting of brush element 19. Correct mounting © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06... -
Page 11: Mounting Of Sweeper Roll
Attention! Avoid clamping. 3. Mount the four gable side bolts. 4. Mount the hydraulic hose bracket on the bar tube. 21. Mounting gable side 22. Gable side bolts 23. Bracket for hydraulic hoses © HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 6/4/06...
Need help?
Do you have a question about the SL and is the answer not in the manual?
Questions and answers