Installation; Mounting - ProLights ATMOSFERA903 User Manual

6

- 2 - INSTALLATION

2.1 Mounting

The ATMOSFERA903 may be set up on a solid and even surface. By means of the fixing facilities of the base
plate, the unit can also be mounted upside down to a cross arm. The base plate is shown in fig.4. For fixing,
stable mounting clips are required. According to the figure, the bolts of the brackets are placed into the
openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place
must be of sufficient stability and be able to support a weight of 10 times of the unit's weight. When carry-
ing out any installation, always comply scrupulously with all the regulations (particularly regarding safety)
currently in force in the country in which the fixture's being used.
• Install the projector at a suitable location by means of the C clamp.
• Always additionally secure the projector with the safety rope from falling down. For this purpose, fasten
the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.
• Adjust the position of the projector using the mechanical system (2).
CLAMP
ATMOSFERA903
1
Fig.5
Individual panel excursion:
-100°-/+100°
CLAMP
SAFETY
CABLE
Fig.4
2
+100°
-100°