Precautions When Connecting - Casio fx-9860G SD User Manual

k Connecting to a Projector
You can connect the calculator to a CASIO projector and project calculator screen contents
onto a screen.
u Connectable Projectors (As of January 2007)
XJ-S35
• You can also connect the calculator to a YP-100 Multifunctional Presentation Kit and
project from the projectors other than the model shown above.
u To project calculator screen contents from a projector
1. On the calculator, enter the LINK mode and configure the "Wakeup" and "Capture"
settings as shown below.
2. Use the USB cable that comes with the calculator to connect to the projector (or
YP-100 unit).
u Precautions when Connecting
• Be sure to configure the calculator's "Wakeup" and "Capture" settings before connecting.
• An hourglass figure may remain projected on the screen after you connect the calculator
to a projector (or YP-100). If this happens, performing some operation on the calculator
will restore normal display.
• If the calculator stops operating normally, disconnect the USB cable and then reconnect
it. If this does not correct the problem, disconnect the USB cable, turn the projector (or
YP-100) off and then back on, and then reconnect the USB cable.
12-5-3
Image Transfer
20061201 20050401