1.2. Types of pipe couplings
USA (single clasp)
To join pipe to valve block
(end coupling)
1.3. Process for joining steel pipes
Cut hose perfectly square
Use a saw; do not use
a hose cutter
Fit nut and ring to the
pipe in the shown order
Oil the cutting ring
Cutting edge of the ring
towards the end of the pipe
V700 - 11/2017
UDA (double clasp)
To join pipe to valve block
(end coupling)
Remove burrs inside and outside
- Screw on the cap
nut by hand as much
as possible
- Push the pipe up
against the bottom of
the coupling.
- Tighten the nut with
a spanner 1,5 turns;
the pipe must not be
able to rotate.
Fully tighten
5/40
MP sava3 Hidraulic Power Unit 1 ¼" 1 ½"
CODO (double clasp elbow at 90º)
To join a steel pipe and a hose
Clean the hose inside
with a non-fray cloth
Unscrew the cap nut
and check that the ring
is firmly gripping the
hose
MTMECMPsava3_700_EN