Table of Contents
Advertisement
n
Place the removed HDD unit on the cushion with the
warranty label side down.
HDD unit
Installation procedures
1. Insert a new HDD unit into the slot gently, and press
the levers in the direction of the arrows to lock the
HDD unit.
2. Attach the HDD No.label which has same number as
removed HDD to the front of the new HDD unit.
. HDD No. label : 3-605-401-01
HDD No.label
MAV-70
Cushion
Label side down
HDD unit
Levers
3. See the LCD display, and make sure that the status is
"Stp".
Exit
Disks
: Exchange
>Stop
Start
*1* -2- -3- -4- -5- -6- -7- -8-
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
4. Install the front panel (lower). (Refer to the Section 2-
2-1.)
Starting the HDD
Set the menu select cursor to "Start", and press the ENTER
key.
Exit
Disks
: Exchange
Stop
>Start
*1* -2- -3- -4- -5- -6- -7- -8-
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
The drive will start, and a rebuild operation is automatical-
ly executed when spin-up of the drive is completed.
n
The menu "Service : Disks : Exchange" also enables you
to stop or start up a HDD. The menu "Service : Disks :
Exchange" is used to stop a HDD without "Req" (drive
exchange request).
Select and stop a HDD with extra care. If two or more
HDDs are selected, recording/playback may be disabled.
With a rebuild request for HDD has been generated, if
other HDD is stopped, recording/playback may be
disabled.
>Exit
Service
: Disks
Mark
Stop
*1* -2- -3- *4* -5- -6- -7- -8-
Start
Rdy Rdy Rdy Req Rdy Rdy Rdy Rdy
2-4. Replacement of Main Parts
: Exchange
2-9 (E)
Advertisement
Table of Contents
