Table of Contents
Advertisement
2-2. Removal/Installation of Cabinet
2-2. Removal/Installation of Cabinet
2-2-1. Front Panel Removal/Installation
n
Be sure to put on the earth-band to establish a ground when
removing/installing the ornamental panel A and the front
panel (lower) during the power on. If not, this may cause
malfunction.
Ornamental Panel A Removal
1. Loosen the two screws (with stoppers) on the orna-
mental panel A.
2. Remove the ornamental panel A.
RK 4x20
Ornamental panel A
RK 4x20
2-2 (E)
Ornamental Panel A Installation
1. Attach the ornamental panel A to the unit as shown in
the figure, and tighten the two screws. At this time,
press the shield plate against inside of the unit to avoid
the shield foam from peeling off.
Shield plate
Shield foam
Ornamental panel A
RK 4x20
Ornamental panel A
RK 4x20
MAV-70
Advertisement
Table of Contents
