Modules And Installation Hardware; Table 2-1 Modules Of Neax 2000 Ips System - NEC NEAX2000 ND-91649 General Description Manual

SYSTEM CONFIGURATION

Modules and Installation Hardware

The NEAX 2000 IPS is comprised of up to 8 Port Interface Modules (PIMs).
Modules
(1) Port Interface Module (PIM)
A PIM provides 13 card slots for common control, Line/Trunk (LT), and Application Processor (AP) cards. It
also houses an AC/DC Power Supply (or DC/DC Power Supply), optional DC/DC Power Supply (for -48V),
and batteries for protection from short-term (about 30 min.) power interruption.
Four champ connectors for Line/Trunk (LTC 0 to 3) are located at the lower front side of the PIM.
A PIM provides a maximum of 12 card slots for Line/Trunk (LT) and Application Processor (AP) cards. At
maximum configuration, the system is comprised of 8 PIMs.
(2) Battery Module (BATTM)*
The BATTM is an optional module for installing optional long-term (about 3 hours) backup batteries. The
BATTM is designed to accommodate batteries covering up to a 4-PIM system (2 BATTMs support maximum
system configuration).
The BATTM is available for Floor Standing Installation. (When the system is Wall-mounting/19-inch
Rack-mounting configuration, the BATTM cannot be installed with the PIM.)
Abbrev
PIMMD
PIM MF
BATTM
* Battery Module is available for Latin America.
CHAPTER 2
Page 14
PIM MD PIM MD
(PIM3) (PIM7)
PIM MD PIM MD
(PIM2) (PIM6)
PIM MD PIM MD
(PIM1) (PIM5)
PIM MD PIM MD
(PIM0) (PIM4)
Single MP System

Table 2-1 Modules of NEAX 2000 IPS System

Name Code
SN1617 PIMMD
SN1658 PIMMF
SN1619 BATTMB
PIM MD
(PIM3)
PIM MD
(PIM2)
PIM MD
(PIM1)
PIM MF
(PIM0)
Dual MP System
Remarks
PIM 0 ~ PIM 7
PIM0 for dual MP system
1/STACK, Max.2/system
ND-91649(E)
PIM MD
(PIM7)
PIM MD
(PIM6)
PIM MD
(PIM5)
PIM MD
(PIM4)