NEC MultiSync XP29, XM29 Xtra User Manual page 10

Terminal Board
SPEAKERS MUST HAVE
MORE THAN 5WATT RATING
IMPEDANCE 8 OHM
EXT SPEAKERS
RIGHT LEFT
SPEAKER SELECT
INT EXT
AC IN
H RGB 2
R/C /P , G/Y/Y, B/C /P / H/CS and V IN (BNC) ... These are analog RGB and
R R B B
component signal input terminals. Connect external components with R,
G, B, H, and V output terminals to these analog RGB input terminals. Be
sure that the RGB connection cable is correctly attached to the
corresponding terminals.
R/C /P , G/Y/Y, B/C /P / ,H/CS and V THROUGH OUT (BNC) ...... Connect to a
R R B B
second monitor's RGB inputs to relay the RGB signal inputs at R, G, B, H,
and V IN.
75 /HIGH Impedance Select Switches for RGB and HV .... S e t t o " 7 5
during normal operation. In multiple connections using R, G, B, H and V IN
and OUT terminals, set to "HIGH" on all but the last monitor. Set to "75 "
on the last monitor only.
I DIP Switch
DIP SW ..... This DIP switch sets Sync. Control, the Intelligent Power
Manager, external control on/off, remote control on/off, and OSM control
menu control on/off. See pages 17 and 18 for more details.
J REMOTE IN/OUT
Connect the optional remote cable, included with the optional remote
control, to the REMOTE IN terminal. The REMOTE OUT terminal is used
to connect several monitors together and allows all of the monitors to be
VIDEO 1
BNC S
AUDIO
75
75
R L(MONO)
IN
HIGH HIGH
IN
THROUGH THROUGH THROUGH
OUT OUT OUT
VIDEO 2 RGB AUDIO
BNC S
AUDIO
75
R L(MONO) R
IN
HIGH
IN IN
THROUGH THROUGH THROUGH
OUT OUT OUT
K PC/EXT CTL IN(D-Sub 15-pin)
"
I J
RGB1
DIP SW REMOTE
ON
IN
1 2 3 4 5 6 7 8
RGB 2
R/C /P G/Y/Y B/C P
R R B B
75
L(MONO)
IN
HIGH
THROUGH
OUT
H
controlled by one remote control.
NOTE: Up to 50 monitors can be connected in the serial connection
(This can be done only when the supplied remote cable is used.).
This terminal is used when power ON/OFF, input selection, AUDIO MUTE,
PICTURE MUTE, and DEGAUSS are operated externally (by external
control). See also page 46 for external control port pin assignments. You
can also use this connector to connect your PC to control the MultiSync
XP29 Xtra/XM29 Xtra monitor. This allows you to utilize your PC and serial
communication protocol to control the monitor.
NOTE: Select EXT. CONTROL ON by setting pin No. 6 of DIP SW to
the ON position when operating the monitor by external control.
NOTE: When in the EXT. CONTROL mode, the following operations of
the supplied wireless remote control are not possible: Power control
ON/ OFF, Input selection, and Degauss switch ON/OFF.
PC/EXT CTL OUT (D-Sub 15-pin) ..... Connect to a second monitor' s PC/EXT
CTL input to relay the signal input at the PC/EXT CTL IN. The PC/EXT CTL
OUT terminal is used to connect several monitors together and allows all of
the monitors to be controlled by one external control. No. 6 pin (EXT.
CONTROL) of DIP SW must be set to the ON position on all of the
monitors.
9
K
PC / EXT CTL
IN
OUT
H/CS V
75
HIGH
10
10