Table of Contents
Advertisement
Submit
Use this button to save configuration changes.
Note2:
If you want to validate the configuration, you should close the
ByPassUI window first to quit and reset the NIC card. When the warning
window pops up, click Yes to quit and reset the NIC card, as shown in Figure
below.
Note3:
To verify the setting of watchdog timeout value work or not, you can
type "BypassUI.exe Stop_Service" in a command prompt window and NIC
card will switch from normal to bypass mode when watchdog timer count down
to zero.
Figure: Submit
Figure: Validate the Configuration
27
http://www.tyan.com
Advertisement
Table of Contents
