Table of Contents
Advertisement
4. Drive and pre-tighten the anchor bolts into the holes in the wall through
the screw holes on the Wall Mounting Bracket.
Depending on the condition of the
wall, bolt at least 8 points
5. Connect the Brackets with each other using bolts, from left to right and
from top to bottom direction. After connecting the Mounting Brackets,
check the balance and fully fasten the bolts to the wall.
Wall
Fasten the Mounting Brackets with
M6 bolts.
2.3.3 Installation and Cable Connection of BMA and
BPU for Wall type
1. Assemble the Pack Mounting Bracket to the BMA.
2. Assemble the BMA to the Wall Mounting Bracket using the handle.
* Depending on the BMA location on the wall, the position of the handle on the BMA varies.
* The Design Cover of the BPU should be removed before installing the BPU to the Mounting
Bracket.
Wall
3. In the marked part, assemble the corner bracket and double corner cover
first and then install the next BMA.
8
Information of hole position (mm)
After check the balance and fully
fasten the bolts to the wall
Pack Mounting Bracket
4. Once all the BMAs and BPU are installed, assemble the Corner Brackets
on all corners of the BMA and BPU.
(A : Corner Bracket 1ea, B : Corner Bracket 2ea)
5. Once all the BMAs and BPU are installed, start the cable wiring between
the BMAs and BPU. Make sure that the cabling order is the same as the
installation order of the BMA as the Wall-mounting Layout and the BPU is
always the last one in the order.
6. Connect the Terminal Resistor, End Connector and Connector Cover to the
Bottom Terminal Block of the first BMA in order of the 'Wall-mounting
layout'
Double Corner Cover
Corner
Bracket
Double Corner Cover
Corner Bracket
Terminal Resistor
End Connector
M6 Bolt
Connector Cover
Advertisement
Table of Contents
