Table of Contents
Advertisement
When adding Optional Standing Bracket
*Optional Standing Bracket is for additional purchase and is not included in basic package.
2. Fix the first BMA to the wall.
1) Assemble Fixing Brackets on the first BMA.
Fixing Bracket
M6 Bolt
(a torque of 5N·m)
2) Move the first BMA to the wall and mark the drill point for the Fixing
Brackets. Drill holes at the marked points and fix the BMA to the wall.
Recommended fastener diameter/length : 10mm/40mm
3. Connect the Terminal Resistor, End Connector and Connector Cover to the
Bottom Terminal Block inside the BMA.
* Terminal Resistor, End Connector and Connector Cover are included in the BPU package.
Wall
4. Connect the Inter Cable to the Top Terminal Block inside the BMA.
Wall
5. Tidy up the cable by inserting in the attachable path inside the BMA and
fasten the cable using the Tie hole.
Bolt 8ea(a torque of 5N·m)
Basic Standing Bracket
Pack Standing Bracket
Wall
Terminal Resistor
End Connector
Connector Cover
M6 Bolt
Communication
Power
Inter Cable
After connection,
M6 Bolt
fasten the bolts.
Connector color : Black
CAUTION
Be careful not to damage the cable.
6. Install the second BMA in front of the first BMA.
Wall
Wall
CAUTION
When the second BMA is installed in front of the first BMA, make sure that the
Inter Cable does not interfere between the BMAs.
When adding Optional Standing Bracket
Wall
7. Apply the Wire Harness along the attachable path as the below image and
connect it to the Bottom Terminal Block of the second BMA.
Power
Tie hole
Tie hole
Corner Bracket
M6 Bolt
(a torque of 5N·m)
* The Corner Bracket assembled on the
first and second BMA should divide the
cables of the Wire Harness in to two part,
with each part having two cable lines.
Corner Bracket
After connection,
fasten the bolts.
Connector color : Green
Inter Cable
Communication
M6 Bolt
5
Advertisement
Table of Contents
