Table of Contents
Advertisement
D R AW ER S
To remove a drawer, pull drawer forward until it stops.
Use a Phillips screw driver to remove the two (2)
screws securing the drawer to the slides, then lift the
drawer up and out of unit. (See Figure 8). To reinstall,
pull drawer slides all the way forward on unit, and then
slide the drawer onto the slides until the hook on the
back of the slide is over top of the drawer, reinstall the
screws using the Phillips screw driver.
FREE ZER S TOR AG E
W IR E SHELV E S
Remove the top foam piece holding the wire shelves. Carefully remove shelves and set aside. (See Figure 9).
Remove all other packing material. To install, insert wire shelf into the shelf standards on the back wall, with the
front tilted upward, and then lower the front until it stops. (See Figure 10). To remove or adjust a wire shelf, tilt up,
and then lift up and out.
FIG. 9.
Interior packaging.
W IR E B A SK E T S
To remove a basket, pull drawer forward until it stops.
Use a Phillips screw driver to remove the two (2)
screws securing the basket to the slides, then lift the
basket up and out of unit. To reinstall, pull drawer
slides all the way forward on unit, and then slide the
basket onto the slides until the hook on the back of the
slide is over top of the rails, reinstall the screws using
the Phillips screw driver. (See Figure 12).
TEC_TM_065 REV. B
C A B I N E T S E T U P
FIG. 8.
FIG. 10.
Hook the shelves into the shelf
standards.
FIG. 12.
03/31/2022
Drawer slide screw locations.
FIG. 11.
Final wire shelf installation.
Drawer slide screw locations.
T RUE 42 /4 8 IN STA L L M A NUA L
Page 33 of 48
Advertisement
Table of Contents
