Table of Contents
Advertisement
SHELVING , BINS , DR AWERS
All shelving and door bins come packaged inside the
unit. (See Figure 1)
REFRIG ER ATOR S TOR AG E
G L A S S SHELV E S
Remove the top foam piece holding the glass shelves. Carefully remove shelves and set aside. (See Figure 2).
Remove all other packing material. To install, insert glass shelf into the shelf standards on the back wall, with the
front tilted upward, and then lower the front until it stops. (See Figure 3). To remove or adjust a glass shelf, tilt up,
and then lift up and out.
FIG. 2.
Remove shelving from interior
packaging.
D O O R BIN S
The door bins are located in the bottom drawer of the refrigerator. (See Figure 5). To install, push tabs into the
slots in the door and slide downward unit it stops. (See Figure 6). To remove or adjust a door bin, lift up and away
from door back.
NO T E: BE C AU T IOU S O F P L A CING TA L L I T EM S IN T OP D O O R BIN, A S I T EM S MIGH T IN T ER F ER E
W I T H UI C ON T R O L PA NEL .
FIG. 5.
Packaged door bins.
Page 32 of 48
T RUE RE S ID E N TI A L
C A B I N E T S E T U P
FIG. 1.
FIG. 3.
Hook the shelves into the shelf
standards.
FIG. 6.
Hook the door bins into the door slots.
03/31/2022
®
Interior packaging.
FIG. 4.
Final glass shelf installation.
FIG. 7.
Final door bin installation.
TEC_TM_065 REV. B
Advertisement
Table of Contents
