Table of Contents
Advertisement
Message
Binding is not possible because the length
of the body and cover of perfect binding is
not consistent.
Check the settings.
(The job has been deleted.)
Binding is not possible because the Perfect
Binder has detected an error in the
thickness of the body.
Check the settings.
(The job has been deleted.)
Set paper for the body of the perfect binding
in the tray below.
Tray:
Size:
Some finishers are off.
To use the finishers, turn them on, and turn
the power on with the power key on the
operation panel.
The maximum body size allowed for perfect
binder stacking has exceeded. Check the
settings.
(The job has been deleted.)
Double feed might have occurred.
To continue, check the pages after the
binding is completed.
Cover width that cannot be handled by the
Perfect Binder has been detected.
Check the settings.
(The job has been deleted.)
Paper width that cannot be handled by the
Perfect Binder has been detected.
Check the settings.
(The job has been deleted.)
The output tray of the Perfect Binder is full.
Remove the booklets.
Pressing the ejection button will eject the
booklets.
Action to Take
The combination of the paper sizes for the body pages and
the cover is incorrect as different size paper from the original
size is loaded in the feed tray.
Load cover paper of the same size as that of the body pages.
With the original data that has been sent, the number of
pages is too few and the width of the spine is not enough for
binding the cover. Otherwise, the body is too thick for binding
the cover. Check the original data.
For more information on the available width, see
"Specifications" (p. 3-2).
There is no paper in the tray for the body pages. Otherwise,
paper of a different size has been loaded. Load the right kind
of paper in the specified tray.
The power of the Perfect Binder is off. Turn on the power of
the Perfect Binder.
There is a sequence to turning the power of the Perfect
Binder on. For more information on turning the power on, see
"Power Supply" (p. 21).
Original data exceeds the maximum stacking capacity.
(1) Touch the [Close].
(2) Edit the data and send it again.
For more information on the binding capacity (thickness),
see "Usable Paper" (p. 12).
Paper is jammed in the body sheet stacker. Remove the
jammed paper and touch [Cancel] or [Continue]. If the
printing is continued, check if the booklet has misbound or
not.
The booklet cannot be bound with the current cover size
(width).
Touch [Close] and send original data with the available cover
size. For more information on the correct combination of the
cover and body pages, see "Usable Paper" (p. 12).
The booklet cannot be bound with the current body pages
size (width). Touch [Close] and send original data with the
available body pages size. For more information on the
correct combination of the cover and body pages, see
"Usable Paper" (p. 12).
The booklets ejected to the Perfect Binder's output tray
exceeds the maximum stacking capacity.
Remove the booklets and press the eject button.
• Some booklets may be left inside the unit. Press the
eject button until no booklet is ejected.
Troubleshooting
2-11
Perfect Binder User's Guide
2
Advertisement
Table of Contents
