Setting the Binding
Functions
On the [Maintenance] screen of the printer, you can
check the temperature of the glue unit in the
Perfect Binder. Also, from the [Home 2] screen, you
can configure the functions for manual binding.
Glue Temperature
You can check the status of the glue unit (glue and
glue tank) before sending a binding job.
The binding job will not start if the glue unit is not
yet at an appropriate temperature. If the glue is too
cold, touch [Preheat].
• It may take a long time to warm up the glue unit
to the suitable temperature. It is recommended
to confirm the glue unit temperature before
sending the perfect binding job.
• On the [Glue Temperature] screen, the glue unit
temperature is indicated with the bar (five
levels) and message.
• All jobs sent to the printer are not printed until
the warming-up perfect binding job is finished.
1
On the [Maintenance] screen of the
printer, touch [Glue Temperature].
Operations of the Binding Job
2
If the glue temperature is low, touch
[Preheat].
• Touch this button in a state where the front, side
cover, and the cover sheet inserter are closed.
When the cover is opened, you cannot touch
the [Preheat].
• When the Perfect Binder is in the binding mode,
you cannot use the [Preheat].
• This function can also be configured with the
RISO Console.
Perfect Binder User's Guide
1
1-9