Inch Drive; Primary Hard-Disk Drive - Dell Dimension XPS T Series Owner's Manual

5.25-Inch Drive

1 Drive-mounting screws (3)
To remove the 5.25-inch drive, perform the following steps:
1. Remove the bezel.
2. Remove the drive cage.
3. Remove the three drive-mounting screws, and slide the drive out of the drive bay.
When you replace a drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional information
about jumper settings on EIDE drives, see

Primary Hard-Disk Drive

1 Primary hard-disk drive
2 Card guide assembly
3 Drive-assembly mounting screws (2)
To remove the primary hard-disk drive, perform the following steps:
1. Remove the bezel.
2. Remove the two drive-assembly mounting screws.
3. Lift the primary hard-disk drive out of the card guide assembly.
4. Disconnect the DC power and interface cables from the back of the drive.
To reinstall the primary hard-disk drive, place the drive's circuit board toward the front of the chassis.
When you replace a hard-disk drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional
information about jumper settings on EIDE drives, see
EIDE Subsystem.
EIDE Subsystem.