Dell Dimension XPS T Series Owner's Manual page 16

4 Tabs (6)
To remove the drive cage, perform the following steps:
1. Remove the bezel.
2. Note the location and orientation of all cables attached to the drives in the drive cage, then disconnect the cables.
3. Remove the screw that secures the drive cage to the chassis.
4. Slide the drive cage forward approximately 1/2-inch, then lift it up (to the side for the desktop chassis) and away from the chassis.
The side of the chassis contains three detents that secure the drive cage to the side of the chassis. The drive cage may be slightly difficult to
slide forward until it detaches from these detents.
3.5-Inch Front-Panel Insert
1 Tabs (2)
2 Release tab
To remove a 3.5-inch insert, perform the following steps:
1. Remove the bezel.
2. From the back of the bezel, as shown for the mini tower chassis, press the release tab to the side, rotate the insert toward you, and remove it
from the bezel.
NOTE: For mini tower computers, you must remove the upper insert to remove the lower insert.
5.25-Inch Front-Panel Insert