Table of Contents
Advertisement
Lower 3.5-Inch Drive
NOTE: This drive bay is used only in mini tower systems.
1 Drive-mounting screws (3)
To remove the lower 3.5-inch drive, perform the following steps:
1.
Remove the bezel.
2.
Remove the drive
cage.
3. Remove the three drive-mounting screws, one from the bottom and two from the left side.
4. Slide the drive out of the drive cage.
When you replace a drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional information
about jumper settings on EIDE drives, see
To insert the bottom drive back into the bay, you must slide the drive over the two small grooves on the bottom of the bay.
3.5-Inch Diskette Drive
1 Drive-release tabs (2)
To remove the 3.5-inch diskette drive, perform the following steps:
1.
Remove the bezel.
2. Disconnect the power and interface cables from the back of the diskette drive.
3. Press the two drive-release tabs, and slide the drive out of the drive bay.
Before you install the new drive, transfer the drive-release tabs to the replacement diskette drive.
EIDE
Subsystem.
Advertisement
Table of Contents
