Table of Contents
Advertisement
Page 24 - Repeater Base Stations
Attaching a Directional Aerial
The Repeater Setup Program
Installing the Repeater Setup Program
Connecting a Repeater for Programming
Page 24
38DHB0002UKCA – Issue 8 (26/03/2002)
The directional aerial is supplied with a wall mounting plate, screws and wall fixings.
It also includes a 0.9m lead (fixed length) for connection to the directional aerial
socket on the back of the Repeater.
The face of the aerial should be mounted perpendicular to the parent DBS. The
DECT system should be installed and the position of the Repeater plus directional
aerial tested by making calls before finally fixing the wall mounting plate into place.
The directional aerial then clicks into the wall mounting plate.
Before a Repeater can be used, it must be set-up with various settings; e.g. the
base station number, system number, etc. The Repeater Setup program runs on a
Windows based PC and require the serial lead and phone doubler from a DECT
Repeater Programming kit
The Repeater Setup program is supplied on floppy disks as a self-installing program
(must be V3b). It is also available from the web site
(https://emea-businesspartner.avaya.com/index.asp) as a self-extracting file
Windows 3.x
1. Insert the first disk
2. In program Manager, select File and then Run
3. Type a:\setup.exe and then click on OK
4. Follow the on-screen instructions for installing Admin program
Windows 95/NT
1. Insert the first floppy disk
2. Click on Start. Select Settings and then Control Panel
3. Select Add/Remove Programs
4. In the Add/Remove Programs Properties menu click on the Install/Uninstall
tab. Click on the Install button
5. Windows will scan the floppy disk for a suitable installation file
6. When it has located the file setup.exe on the floppy disk, click on Finish
7. Follow the on-screen instructions for installing Admin program
The Repeater Setup kit includes an adaptor and a programming lead.
The programming lead incorporates special components.
Do not use any other serial lead
1. Use the doubler to connect the serial lead to the Repeater in parallel with the
power supply connector. Ensure that the power supply is on
2. Connect the serial lead to the PC on which the Repeater Setup program is
installed
The Repeater Setup Program
Installation Manual
INDeX CSLC
Advertisement
Table of Contents
