Table of Contents
Advertisement
Page 18 - Installation
Changing CSLC User Numbers
Subscribing Handsets
Page 18
38DHB0002UKCA – Issue 8 (26/03/2002)
To change the extension number of a current 20DT handset, including Mobile Twin
Numbers (see page 20), perform the following (Level 9.0+ software only)
To change a handset's number :
1. From the Administration menu, select Linecard Information
2. Select Linecard and enter the address of the CSLC cassette
3. Select Setup and Handset registration and use the left and right cursor keys to
move through the Mobile User directory numbers
4. Select Delete and remove the existing DECT handset number
5. Unsubscribe the handset (see "Removing a Subscription" on page 19)
6. Check that the new user number is allocated to the Mobile User Group (default
set to 114) and it's Type has been set to Mobile. If not create new number and
add to mobile group
7. From the Administration menu, select Linecard Information, Linecard, Setup
and Handset registration
8. From Select new target, add the number created above
9. Perform a subscription request from the 20DT handset (see "Subscribing
Handsets" on page 18 ).
Once a handset's serial number has been registered (see page 17), that handset
can be subscribed to the system. To do this, subscription must first be allowed on
the INDeX. The subscription process is performed as follows:
To enable handset subscription :
1. From the Administration menu, select Linecard Information
2. Select Linecard and enter the address of the CSLC cassette
3. Select Setup
4. Set Allow subscription to yes (toggles between yes and no)
5. Note the number shown on the same line after the Allow subscription setting.
This is the DECT system's own serial number (ID) and is required when
subscribing a handset to ensure that you attempt to subscribe to the correct
DECT system.
To subscribe an INDeX 20DT Handset
It is recommended to only subscribe one handset at a time.
1. Press MENU and then > until LOGIN appears, then press
appears
2. Press > until SUBSCRIPTION CREATE appears, then press
3. Press > until required System ID number appears, then press
4. Press > until CREATE SYSTEM 1 appears, press > until required system ID
The handset displays the ID's of any systems in range. If there are several
systems locally, use < and > to display the different ID numbers found
6. When the required ID is shown, press
7. AC: _ _ _ _ _ _ appears. If required enter an Account Code. Press
If for some reason your handset cannot subscribe it displays FAILED. Press
try again
8. Press MENU to finish
Changing CSLC User Numbers
. SELECT LOGIN
Installation Manual
INDeX CSLC
to
Advertisement
Table of Contents
