Tools required: ladder, hammer screwdriver (not included) Parts List Center Connector Long Bar Short Bar Corner Connector Arm Connector Lintel Lintel Post Parts List Air Vent Canopy Screen...
Page 3
Hardware Used in Step Bolt 1/4”-0.6” Bolt 1/4”-1.25” Wrench STEP1: Attach lintel (F-1) to lintel (F-2) then to arm connector (E) with bolt (J). Attach 4 lintel assemblies as illustrated. Attach lintel (F-1) to lintel (F-2) to post (G) with bolt (I), make them into a square. Attach the corner connector (D) to lintel (F-1\F-2) with bolt (J).
Page 4
Hardware Used in Step Bolt 1/4”-1.25” Attach the long bar (B), short bar (C) to center connector (A), then install this assembly at the top of the shelter. Attach the long bar (B) to bar (B1), then attach the bar (B1) and corner connector (D) to the assembled frame with bolt (J).
Page 5
Hardware Used in Step Cover the canopy (M) onto the top of the gazebo (Do not cover tightly), then cover the air vent (L) onto the small top. Tie each corner of the canopy and cover the four corner knots onto the end of the bar (B1), then tie each side in the missdle and cover the middle knots onto the end of the short bar (C).
Hardware Used in Step Plastic Hanger N:Netting P:Plastic Hanger 8.The screen (N) is hanged to the slip tube with plastic hangers (P). Your sunshelter is now ready to be used. MAINTENANCE: 1. This sun shelter is not a permanent structure and should be disassembled & stored away after use.