RS 29 18.0 Overview Cutting support Rear handle LED lighting Slot for battery For illuminating the working area. Li-ion battery (2.5 Ah or 5.0 Ah) Tool holder Release button for battery Tool holder lock State of charge indicator Cutting support lock...
RS 29 18.0 Important safety information Safety instructions for sabre saws Hold the power tool by the insulated gripping surfaces when performing an WARNING! operation where the cutting accessory Read all safety instructions and general may contact hidden wiring or its own instructions.
RS 29 18.0 Noise and vibration When working, hold the power tool firmly with both hands and ensure that you have a secure footing. The power tool is The noise and vibration values have been controlled more securely if held with both determined in accordance with EN 60745.
RS 29 18.0 Instructions for use Before switching on the power tool Unpack the power tool and accessories and check that no parts are missing or damaged. NOTE The batteries are not fully charged on delivery. Prior to initial operation, charge If one of the LEDs flashes, the battery must the batteries fully.
Page 7
RS 29 18.0 Adjusting the cutting support WARNING! Remove the battery before carrying out any work on the power tool. The cutting support should always rest on the material when sawing so as to avoid excessive vibrations. It is possible, for example, to limit the saw blade cutting depth by adjusting the cutting ...
RS 29 18.0 Operating instructions Switch on orbital stroke to perform plunge cuts. WARNING! Place the saw on the workpiece with the Always hold the power tool firmly with both bottom edge of the cutting support in hands! such a way that the saw blade does not touch the workpiece.
RS 29 18.0 Disposal information Clean the power tool and ventilation slots at regular intervals. Frequency of cleaning is dependent on the material and duration of WARNING! use. Render disused power tools unusable by removing the power cord. Regularly blow out the housing interior and motor with dry compressed air.
2011/65/EC. the power tool with products from other Responsible for technical documents: manufacturers. FLEX-Elektrowerkzeuge GmbH, R & D Bahnhofstrasse 15, D-71711 Steinheim/Murr Eckhard Rühle Klaus Peter Weinper Manager Research &...