Advertisement
Installation on Hollow Metal Frame:
E
E
�
'St
Fail-Safe/ Fail-Secure Reversible
1. Remove the plug and
take out the round screw.
*Factory default setting is Fail-Secure.
Installation Steps
1
Measure the vertical and horizontal position
of the latch bolt on the door leaf.
4
Drill and cut the frame according to
the template.
Please ensure that there is no back pressure on the keeper from the latch. As with most strikes this may cause the strike
ffiNote
to bind and malfunction. It could also cause undo pressure on the solenoid and eventual failure of the strike.
CAL-ROYAL
P R O D U C T S,
I N C. U.S. A.
' '
E
' '
E
' '
2. Reverse the round screw.
2
Mark the position of the latch bolt on
the door jamb as shown in figure.
Install the mounting tabs.
'�
Installing the Crimp Connectors
3. Put back the round
screw and plug.
Place the wire inside the connector and use
pliers to press down on the head of the
connector evenly.
3
Align the installation template
to the marked line.
6
Connect to the power and test the electric
strike before finally mounting the unit.
DWG # ELG8011, P2/2 , 20220407
Advertisement
