Upgrade Verification - HP HP3000/9x9KS I/O Upgrade Manual

Enterprise servers
Table of Contents

Advertisement

NOTE
Do not discard the cover plate. If a core I/O or expansion I/O HP-HSC slot is open, use the
cover plate to close it.
7. Angle the HP-HSC card so that the hooked tabs of the card slide through the desired bulkhead tab slots.
8. Carefully align the extended pins to the HP-HSC card connector on the back of the card and gently press down
to fully seat the card on the connector.
9. Tighten the two (one on each side) captive mounting screws to secure the HP-HSC card to the bulkhead.
10. Insert the core I/O and expansion I/O cards back into their appropriate slots.
11. Connect the interface cable to the bulkhead connectors.
Upgrade Verification
Before performing the procedures in this section, verify that all removed cover plates are reinstalled and
secure.
1. Reconnect the power cord to the rear of the computer.
2. Turn the computer key to the ON position.
3. Observe the Front panel Display and console for any error or fault (FLT) messages.
When all procedures are completewith no errors or faults, reconfigure the system to add the new
HP-HSC path addresses. Refer to the Owner's Guide for configuration instructions. HP-HSC Slot path
addresses are shown in Table 1-4.
Table 1-4
HP-HSC Slot Addresses
Core I/O card, Optional I/O connector
HP-HSC I/O Expansion card, slot 0
HP-HSC I/O Expansion card, slot 1
HP-HSC I/O Expansion card, slot 2
HP-HSC I/O Expansion card, slot 3
HP-HSC I/O Expansion card, slot 0
HP-HSC I/O Expansion card, slot 1
HP-HSC I/O Expansion card, slot 2
HP-HSC I/O Expansion card, slot 3
Location
Primary Four Slot HP-HSC Expansion I/O
Secondary Dual Bus HP-HSC Expansion I/O (K5x0 only)
Device Type
HP-HSC I/O card
10/8 (device addr.)
HP-HSC I/O card
8/0 (device addr.)
HP-HSC I/O card
8/4 (device addr.)
HP-HSC I/O card
8/8 (device addr.)
HP-HSC I/O card
8/12 (device addr.)
HP-HSC I/O card
12/0 (device addr.)
HP-HSC I/O card
12/12 (device addr.)
HP-HSC I/O card
14/8 (device addr.)
HP-HSC I/O card
14/12 (device addr.)
I/O Upgrade
HP-HSC Upgrade
Address Path
1-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

K-class seriesHp9000

Table of Contents