Installation; Selection Of The Correct Locations - Panasonic NR-E411GH-N3 Operating Instructions Manual

Installation

Installation
Choose the right location
1. Placement environment for the refrigerator.
Keep away from heat sources and avoid direct
sunlight to minimize the impact on the refrigeration
capacity and prevent electricity waste.
Choose a well-ventilated location with low humidity
to avoid rust or condensation.
Solid and flat floor
When placing the refrigerator on a floor covered with
carpet, tatami mat or vinyl, place a solid base plate
under the refrigerator to prevent deformation or
discoloration of the carpet.
Place the refrigerator away from other equipment to
prevent noise interference and incorrect images from
being displayed on the TV and other equipment.
Place it in a place where it is easy to clean the power
socket.
Clean the dust regularly.
(So as not to cause fire.)
Before using the refrigerator for the first time
Please wipe the refrigerator interior with a damp soft cloth.
Raise the water supply tank, water purification filter, and ice-making tray.
2. Installation of the refrigerator
If the refrigerator is not installed on a stable ground, knocking sounds are heard when opening/closing the
refrigerator door.
(This may affect the performance of the refrigerator.)
Install the refrigerator on a solid and flat floor.
The refrigerator door may be lowered due to the inclination of the installation site or the floor.
①Remove the leg cover
Insert both hands under the
the leg cover and pull it out.
leg cover
②Rotate the adjustable legs (on the right and left)
to keep the refrigerator stable.
The refrigerator doors tilt downward.
Rotate the adjustable leg on the lower side to
adjust the refrigerator till level and stable, as
shown in the photo on the right.
The refrigerator door may tilt due to foods stuffed
inside or its adaptation to the ground within four
to five days after the installation of the refrigerator.
In this case, readjust the adjustable leg till the
refrigerator becomes stable.
If the refrigerator door remains tilted, then adjust
the base plate underneath the refrigerator.
6
P.19
（ ～
on both sides of
Adjustable legs
Location with good heat dissipation
When vibration noise, discoloration of the wall, or the
condensation on the back causes disturbance, place
the refrigerator 20mm or more away from the wall.
20mm or more above the refrigerator
15mm or more from left and right*
*If the refrigerator is installed against the wall.
(Top view.)
15mm or more from the wall
If the space left is less than 15mm,
the refrigerator door cannot be
opened more than 90°, and
glass trays, etc. may not be
taken out.
P.21
）
③Put back the leg cover.
When the door is lowered
Lower the
adjustable legs on
the right side