Table of Contents
Advertisement
Water supply tank / Water Purification Filter
Remove the cover and
①
clean the Water supply
tank with water.
water
蓋子
supply
tank.
It is recommended to replace the Water Purification Filter every three years.
(Parts sold separately: P. 27 )
If there is incrustation on the Water Purification Filter, it may not be able to make ice properly.
Washable ice-making tray (inside the ice compartment)
Remove and rinse the ice-making tray .
Press
and hold the key for more than 3 seconds to unlock the control panel.
①
Press
to ensure only
Press
and the setting is completed after a beep. (
②Turn the knob in the Ice compartment to the unlock position.
③Pull the lever forwards to take out the ice-making tray.
④Wash the ice-making tray with clean water. Do not wipe the surface with sponge, etc.
(If the ice-making tray is scratched, the ice may not be released properly, which may
cause a malfunction.)
The ice-making tray and its frame cannot be separated.
Do not use a dishwasher-dryer.
Reinstallation
Push the ice-making tray in until a click sound is heard.
①
②Turn the knob to the lock position.
If the ice-making tray is not locked, ice making function is not working.
Press
and hold the key for more than 3 seconds to unlock the control panel.
③
Press
to ensure only
off).
Ice can not be made until [AUTO ICE OFF] is canceled.
Do not put water directly into the ice-making tray after washing.
(Otherwise, ice cubes will stick together or malfunction may occur.)
Case (Ice /Fresh Freezing /Freezer/Vegetable compartment)
Pull out at an angle
Pull out the door as far as
possible, and pull out at an
angle while lifting up the front.
Take out the aluminum
plate
Rotate the Water Purification
②
Filter and take it out from
the
hook.
Hook
Water
Purification
flashes.
flashes. Press
Gently clean the Water
③
Purification Filter in the
water.
Filter
Lock position
LED lights on).
Unlock position
and the setting is completed after a beep. (
Requests
The contact parts of the drawer rails are coated with lubricant.
Don't wipe it off!
→If you brush it off, please consult your dealer.
Do not touch the aluminum plate with wet hands, such as
when cleaning the plate.
(This may cause frostbite to the hands.)
When cleaning the case and aluminum plates, they should
be installed after draining the water and wiping the residual
water droplets.
Appendix
Once a week
Remove the running filler
④
material at the back edge.
Wash with water.
Install the Water Purification
⑤
Filter and refill the running
filler material.
Once or twice a year
Knob
Unlock position
Lever
Lock position
LED lights
Once every three months
21
Advertisement
Chapters
Table of Contents
