Table of Contents
Advertisement
Installation
The distance requested for installation
●The top of the refrigerator and the ceiling at least 30 cm.
●The back of the refrigerator and the wall at least 10 cm.
●The sides of the refrigerator and the walls at least 5 cm.
Area around the installed unit
●Do not locate the refrigerator in a humid place as rust
may form and may cause electric leakage.
●Do not locate the refrigerator exposing to direct sunlight
as the heat and sunlight will increase the temperature.
●Do not locate the refrigerator near heat source such
as cooking stove or oven.
●Do not block the openings around the refrigerator.
●The refrigerator must be located in the place where
there is good air circulation.
●In case of placing the refrigerator on an uneven surface,
adjust the adjustable leg to make the refrigerator stands stably.
Moving or shifting
●When moving or shifting the refrigerator, remove ice maker, etc.
and check to be sure that there is no water in the refrigerator.
●Tilt the refrigerator backward to drain water from the drainage hole.
(To prevent water from leaking out, tilt back the refrigerator slowly.)
LED light and grounding
●The refrigerator LED light, specially designed for this refrigerator, do not replace it by
yourself. If you need replacement, please contact Panasonic Service Center.
●If there is no grounding wiring plug in refrigerator, it should be connected with grounding
connection to prevent electrical hazard from electric leakage.
For safety, the ground connection should be done
(For a refrigerator with plug (2-pin plug) without any grounding wire)
The ground connection will allow prevention of danger resulted from electricity
leakage.
The ground connection can be performed in 2 ways as follows:
1. In the case that the grounding receptacle having been prepared for the socket
(plug socket), connect the ground wire to the screw used for ground connection
at the bottom rear of the refrigerator (regarding the screw used for ground
connection, please notice the
And then connect the other end to the grounding receptacle.
2. In the case that the socket (plug socket) having not been provided with any
grounding receptacle, connect the ground wire to the screw at the bottom
of the refrigerator, (as regards the screw used for ground connection,
please notice the
And then connect the other end to the ground rod as shown in the illustration ②.
Prohibited spots for ground connection
● Gas pipes and water supply pipes (dangers from electric shock or explosion).
● The ground wires of telephone cords and lightning rods (dangers from lightning).
6
symbol) as shown in the illustration ①.
symbol).
Drainage
hole
(Container whose height
is 2 cm or less)
1
Grounding
receptacle
2
Grounding wire
Illustration for the
grounding connection
Advertisement
Table of Contents
