Mega System Tech iCAMView iCV-01a User Manual page 33

Operator:
Viewer:
No Access:
WARNING: If you did not setup the Administrator account in Setup Wizard; you
MUST now set an Administrator permission level BEFORE setting either
"Operator", "Viewer" or "No Access". Failure to do so will result in you being
locked out of iCAMView Web Manager!
"IP Filter"
Visitor can only login from the IP address specified here for security
consideration. You can restrict a user access only from 192.168.1.0/24 by
setting up "192.168.1.*". Otherwise, leave it as "*.*.*.*" to allow the user to login
from any place.
"Max FPS"
This allows the administrator to determine the frames per second ("FPS")
allocated to each type of account. By limiting the FPS, the administrator can
manage the limited bandwidth available. The administrator can set a figure
between 1 to 20 and unlimited FPS.
"Permit Hours"
When the Permission level is set to either "Operator" or "Viewer", the
Administrator can configure and determine the time to which either permission
level can access the camera.
Click "Configure" to bring up the following window. You can set up to 4 different
Permit Hours (in 24hr format). Click "Apply" to save and "Close" to exit.
iCAMView user manual
This permission level allows the user access to
iCAMView menus, but without the permission to amend
them.
This permission level allows the user to access
iCAMView at specific time as set in "Permit Hours" for
seeing camera. The user does not have write permission
and can only access the "Camera" and "Information"
section.
This is to revoke either of the above two permission
levels given to a user. This disables the user account.
Fig.26. iCAMView User Account Settings
Chapter 5: iCAMView Web Manager
-30-