Mega System Tech iCAMView iCV-01a User Manual page 13

Enter an appropriate internal IP Address, Subnet Mask and Gateway for
iCAMView (Refer to Appendix C for an explanation of IP Addresses)
"Obtain an IP address by Bootp"
Allow iCAMView to obtain an IP address using Bootp protocol.
6. Click "Next >" to proceed to xDSL/Cable modem setup.
This section has to be configured to allow iCAMView to access the Internet
through an xDSL.
Select "Enable PPPoE connection" and enter your account and password details
as provided by your ISP.
Otherwise, leave it at the default "Disable PPPoE connection"
iCAMView user manual
Chapter 4: Using iCAMView Utility to Setup IP & Update Firmware
-10-